Depot - Compressor Shed

The society was donated two compressors. They need to be installed near where the greatest demand for air was required.
Interestingly, the compressors were fitted before the walls were erected.

16th May 2009
Finally the compressor room has a light and power point - due to the construction of the electrical store above.

16th May 2009
Trevor cutting holes out the wall liner to go around the light switch.

8 July 2008
The compressor shed has been built with stairs up the side to access storage space above.

4 June 2005
The staff can be seen here sorting out the pipework to plum the air around the building.

4 June 2005
After a good start on the compressor shed back in 2003, we finally finished the work off. One of the orginal compressors failed and needed to be replaced. Thankfully John Couchman donated a AC41 compressor, which we have fitted into the compressor room. We now have plenty of compressed air to get jobs done around the depot.

5 April 2003
Russell and Rod making concrete for the floor of the compressor shed.

5 April 2003
We have been given some second hand compressors and Trevor our resident joiner is building a purpose built shed. This photo shows the floor being layed.

The majority of the photos displayed on this page were taken by Stan Jenkins.

Back to General Depot page

	16th May 2009 Finally the compressor room has a light and power point - due to the construction of the electrical store above.
	16th May 2009 Trevor cutting holes out the wall liner to go around the light switch.
	8 July 2008 The compressor shed has been built with stairs up the side to access storage space above.
	4 June 2005 The staff can be seen here sorting out the pipework to plum the air around the building.
	4 June 2005 After a good start on the compressor shed back in 2003, we finally finished the work off. One of the orginal compressors failed and needed to be replaced. Thankfully John Couchman donated a AC41 compressor, which we have fitted into the compressor room. We now have plenty of compressed air to get jobs done around the depot.
	5 April 2003 Russell and Rod making concrete for the floor of the compressor shed.
	5 April 2003 We have been given some second hand compressors and Trevor our resident joiner is building a purpose built shed. This photo shows the floor being layed.